27″ Front Hairpin Radius Rods – Polished Stainless Steel

$349.99

Overview

Ideal for smaller or full-fendered cars. Rugged, 7/8″ O.D. polished stainless steel tubing is threaded 5/8″-18 NF right hand at each end.

Designed to be used with batwings or axle brackets with a 5″ center to center bolt hole spacing on front tube or I-beam axles only. Not to be used for rear suspensions. Before installing the heim joints or clevis ends, the actual measurement will be center to center 4-1/2″. The angle of the tube will increase the measurement to 5″ after installing the end hardware.

Disclaimer

This product is legal for off road use and non pollution controlled vehicles (1965 & older); however, it has not been tested or approved by the California Air Resources Board (CARB) for highway vehicles in the state of California. By purchasing this product, buyer agrees it will not be used on pollution controlled vehicles in California, or in a state with similar emissions regulations.

WARNING: Cancer and Reproductive Harmwww.P65warnings.ca.gov

Resources

PART NUMBERS

Additional information

Weight 8 lbs
Dimensions 30 × 12 × 4 in
Finish

Polished

Material

Stainless Steel

Quantity

Sold As Pairs