Mustang II Tubular Upper Control Arms – Stock Width

Overview

Bolt on replacement tubular control arms for 1974-78 Mustang II, 1974-80 Pinto/Bobcat chassis or hot rods with stock width (8.25″) Mustang II front suspension conversions. Made out of heavy duty 1″ steel tubing and TIG welded for strength and durability. Includes high quality replaceable screw-in ball joints, cross shafts, rubber bushings. Sold as pairs (left and right). *T-BOLTS SOLD SEPARATELY

RECOMMENDED PARTS:

• Mustang II Tubular Lower Control Arms: R9824
• T-Bolts: R3400

REPLACEMENT PARTS

• Screw-In Ball Joint: R3604
• Cross Shaft Kit: R9823-1KIT
• Cross Shaft Only: R9823-1
• Rubber Bushings: R3407

Disclaimer

This product is legal for off road use and non pollution controlled vehicles (1965 & older); however, it has not been tested or approved by the California Air Resources Board (CARB) for highway vehicles in the state of California. By purchasing this product, buyer agrees it will not be used on pollution controlled vehicles in California, or in a state with similar emissions regulations.

WARNING: Cancer and Reproductive Harm – www.P65warnings.ca.gov

Resources

PART NUMBERS

• R9823