Overview
Our LS tight fit, center exit headers are the perfect exhaust solution to your LS swaps in your street rod! The tight fit, block hugger design accommodates engine bays with limited space and the polished stainless steel finish adds style and performance to any LS setup. These kits come complete with new header bolts, dump tubes, gaskets and (2) weld-on O2 sensor bungs.*MAY NOT BOLT UP TO EXISTING EXHAUST SYSTEM. PROFESSIONAL INSTALLATION HIGHLY RECOMMENDED
Fits:
- LS1/LS2/LS6 Engine Swaps
Kit Includes:
- (2) Headers (Left & Right)
- (2) Reducers
- Mounting Hardware
- Gaskets
Disclaimer
WARNING: It is against the law to install this product on an Emissions Controlled Vehicle.
This product is legal for off road use and non pollution controlled vehicles (1965 & older); however, it has not been tested or approved by the California Air Resources Board (CARB) for highway vehicles in the state of California. By purchasing this product, buyer agrees it will not be used on pollution controlled vehicles in California, or in a state with similar emissions regulations.
WARNING: Cancer and Reproductive Harm – www.P65warnings.ca.gov
Resources
PART NUMBERS
- R9935S